Assembly & Operating Instructions

Step 7
Tighten all attachments.
The Multi-Use Truck Rack is now ready for use.
WARNING: DO NOT EXCEED 250 LB. MAXIMUM LOAD CAPACITY.
FIG 5
Step 5
With the Upright Support inserted, attach the Rear Upright Support Bracket using 2 bolts (A),
2 washers (D), 2 lock washers (E), and 2 nuts (F). With the foot of the Upright Support (6) plumb,
mark and drill two holes in the truck bed. Attach the foot to the truck bed using 2 bolts (A),
2 washers (D), 2 lock washers (E), and 2 nuts (F).
Step 6
Assemble the upper arm (FIG 4)
using button head bolts (G), flat
washers (K) and lock nuts (J).
Use bolt (H) to attach the Ladder
Stop (5), with the Spacer (M) in the
gap of the Horizontal Cross Arm (7)
(FIG 5). Insert the Adjustable Arm
(8) into the Horizontal Cross Arm (7)
and adjust to the desired width.
Secure it by tightening bolt (H).
Insert the Uprights (3) into the
Upright Supports (6). Secure using
set screws (C).
Spacer
M
H
4
Vertical
Support
Arm
Horizontal Cross ArmAdjustable Arm
Ladder Stop
Upright
8
5
7
3
Rear
Upright
Support
Bracket
1
Upright
Support
6
FIG 4
G
G
Note: Height is adjustable, from inside floor
of bed to support arm. Height ranges from
48 Inches to 54 Inches.
Width is adjustable. Adjustable Arm (8)
adjusts from 19 Inches to 32 Inches.
Length is dependant upon length of truck
bed. One piece mounts on front of bed,
one piece mounts on back of bed.
4
Multi-Use Truck Rack