Installation & Assembly

The lag screws should be equally spaced as possible along the support rail, with

the first and last screws no more than 6 inches from the end.

. Measure and mark where each of the end lag screws will be placed before

pre-drilling both holes with a 1/8 inch drill bit. Have someone assist you by

holding the opposite end of the support rail as you drive in the first lag

screw.

Drive the second lag screw in at the other end of your support rail,

then pre-drill and drive in the two in the middle. Be sure to place all the lag

screws directly in the center of your support truss/joist! Failure to secure

all lag screws directly into the center of your support truss/joist may result

in damage and/or injury.

5. Now install your second support rail parallel to the first.

easure about 44

to 52 inches of space from your first rail, depending on the

spacing of your overhead support trusses or joists. Again, be sure to place all the

lag screws directly in the center of your support truss/joist! Again start by pre-

drilling for the two end lag screws. Mount the support rail and drive in the lag