Owner Manual

ASSEMBLY INSTRUCTIONS

STEP 1: SLIP SLEEVES

STEP 2: INSTALLING BOTTOM SHELF

A (4) D (8)

C (1)

Place SHELF (C) on its side and slide the (4)

BOTTOM POLES (A) through the holes in the

SHELF (C). Make sure that the SHELF (C)

corner cylinders are positioned over the SLIP

SLEEVES (D).

Stand the unit upright.

**Use a rubber mallet, if needed, to secure

the SHELF (C).

For easiest assembly, do not attach the TOP (B) and

BOTTOM (A) POLES until instructed. Once connected,

these will be the posts for the Rack.

Note that each POLE (A+B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has

raised horizontal lines inside designed to lock them in

place on the POLE (A+B).

On the BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (D)

at the desired level. Please make sure the arrow faces up

and that the word “TOP” is right side up. Do this for each

BOTTOM POLE (A) and make sure that the heights are

identical for BOTTOM POLE (A).

Slide the pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto the BOTTOM POLE (A). DO

NOT place more than one pair on each POLE (A) at a time.

* For safety and stability, the lowest SHELF (C) should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (D)—this is normal.

*Note: The level side of the SHELF (C) is the

TOP side (the logo on the corner cylinders

should be right-side up.)