Installation Instructions

All information is subject to change without notice Page 4 of 12
Basic Workbench
Do not tip bench on its side, without a shelf attached as it is unstable and may cause
damage. Must use two people to rotate bench.
STEPS
Lay bench top face down on a flat clean surface; such as blanket
or cardboard to protect from scratching.
Insert leg attachment channel into bench top with open area of
channel facing upward. Position attachment channel so that
holes in end flanges are in line with oval and first hole in front
and back flanges of benchtop. Use four (4) 07792-00 screws and
17213-00 nuts to loosely fasten leg and channel together.
Repeat procedure on the other end.
Stand leg weldment in place (leg fits inside attachment channel).
Position leg so that holes in sides of leg weldment are in line
with the holes in the side of the attachment channel. Loosely
fasten leg and channel together with four (4) 07792-00 screws
and 17213-00 nuts. Repeat procedure on the other end.
Do not tip bench on its side, without a shelf
attached as it is unstable and may cause damage.
Must use two people to rotate bench.
Insert adjustable foot or caster bracket into leg so
that holes in the sides of foot or bracket are aligned
with holes in sides of leg. At desired height, fasten
foot to leg with four (4) 07792-00 screws and 17213-
00 nuts or fasten caster bracket with two (2). Repeat
procedure for other legs. Tighten all hardware. This
completes assembly of Basic workbench. Put bench
in upright position.
line with holes in leg. Fasten stringer to leg with four
(4) 07792-00 screws and 100530-00 weldnuts.
Repeat procedure at the other end. Tighten screws
holding leg weldments and attachment channels
together.
Attach stringer to legs along back edges of bench.
Position stringer so that holes in end of stringer are in