Installation Instructions

All information is subject to change without notice Page 10 of 12
Back & End Filler Panels
STEPS
Place end of ledge shelf in between flanges of ledge end. The
two (2) holes on back of shelf must align with top two (2)
ovals on rear flange of ledge end. Align hole in front flange of
ledge shelf with top hole on front flange of ledge end. Fasten
ledge shelf to ledge end with three (3) screws and nuts as
provided. Repeat procedure at the other end.
Ledge Riser for Work Bench Without End Guards and Back Guard
STEPS
Place ledge assembly on bench top so that rear flanges and
sides of ledge ends are flush with back and sides of bench top.
Mark location of two (2) holes of bottom flange of ledge end,
on bench top, at each end. Remove ledge assembly and drill
two (2) .344 (11/32 inches) dia. Holes at marked locations at
each end of bench top. Reposition ledge assembly so that
holes in bottom flanges of ledge ends align with the drilled
holes. Fasten ledge assembly to bench top with four (4) screws
and nuts as provided, two (2) each end. This completes
assembly of Ledge Riser for the Work Bench Without End
Guards and Back Guard.
LEDGE END