Assembly Instructions

End Guards
1
BACK GUARD
1
Parts List "E"
Item Description Req'd.
1 End Guard 1 pair
2 .312 (5/16) - 18 x .500 (1/2) Phillips T.H.M.S. 4
3 .312 (5/16) - 18 Keps Nut 4
Parts List "F"
Item Description Req'd.
1 Back Guard 1
2 .312 (5/16) - 18 x .500 (1/2) Phillips T.H.M.S. 7
3 .312 (5/16) - 18 Keps Nut 7
Position end guard (Item 1) so that the two holes align with the
holes in the side of the attachment channel. Fasten end guard
to channel with (2) screws and nuts (Items 2 & 3) as provided.
Repeat procedure at the other end.
This completes the End Guard assembly.
Position back guard (item 1) so that the ovals in the lower edge of
the back guard are in line with the holes in the back edge of the
bench top. (Flanges on the back guard are to be facing toward
the front). Fasten back guard to bench top with (5) screws and
nuts (Items 2 & 3) as provided.
This completes the Back Guard assembly.
NOTE: The extra (2) screws and nuts are used when the end
guards and back guard are combined on the work bench.
End Guards and Back Guard Combined
Attach end guards and back guard to work bench as stated in the
separate assemblies for the end guards and back guard above.
Flanges on back guard are to be located inside of the end guards.
Fasten end guards to back guard with (1) screw and nut (Items 2
& 3) as provided, at each corner.
This completes the assembly for the End Guards and Back Guard
Combined.
Back Guard
Tools Required: 1. Phillips Screwdriver
2. 1/2" Open End or Box Type Wrench
Tools Required: 1. Phillips Screwdriver
2. 1/2" Open End or Box Type Wrench
~
END GUARD
(1 pr. required)
~
~
3