Installation Instructions

EXISTING WALL SURFACE PREPARATION
• Ensure wall surface is dry, smooth, and free of dust, soap scum, mold or other contaminants. Wipe
wall surfaces with a damp cloth and allow to dry.
• Wall surface must be dry before panels can be applied.
• Ensure that alcove is plumb and square. ( See Illustration 1)
ROUGH PLUMBING & FITTING
• Turn off hot and cold water supplies.
• Remove faucet handles, escutcheons, filler spouts and any other fixtures. (e.g. towel bars, soap
dishes, etc.).
• Use a hammer and chisel to remove objects cemented to walls.
INSTALLATION OVER OLD TILE
• Old ceramic tiles, if solidly adhered to walls, need not be removed. Loose ceramic tiles must be
removed and sub walls sanded smooth.
• Rough up glossy tile surfaces using belt sander with 60-grit sandpaper.
• Surface must be dry, smooth and free of any dust or any other contaminants.
• Wipe wall surfaces with a damp cloth and allow to dry.
IF YOU PLAN TO INSTALL A SHOWER DOOR
• Follow manufacturer's instructions and prepare stud wall accordingly.
PREPARATION
PREPARATION
Wetwall Installation
BEFORE YOU BEGIN
To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local
codes.
• Local building codes vary by location. Observe all local plumbing and building codes.
• Unpack the Wetwall panels and inspect them carefully for damage. Verify that the walls are the
correct size for your installation. Refer to Wetwall Technical Data sheet for specific dimensions for
each model.
NOTE: Take extra care in handling the front surfaces of the panels. Use only non-abrasive cloths to avoid
scratching.
PREPARATION
Must be installed over SHEETROCK/GREENBOARD, CEMENT/CONCRETE or TILE.
pg. 3