Installation & Assembly

www.WETSTYLE.CA - Montreal - Canada
Tel. [phone] - Fax. [phone]
CUBE
TAP DRILLING INSTRUCTIONS
Tap drilling instructions
2. Mark out the center of the hole to be
drilled or use template. See next page.
1. From a hole saw kit, select a 1-3/8”
diameter bit to drill the hole.
3. Install the sink on a stable surface.
Make sure that you are in a comfortable
working position.
4. Hold the drill perpendicular to the
surface.
5. Make sure to apply light pressure
when drilling. You may want to pull the
drill out occasionally to remove any
dust accumulation.
N.B. Material thickness is 3/4”.
90°
August 2008_PRINTED IN CANADA