Installation & Assembly

WETSTYLE
Installation guide
march 2016
ABOVE-COUNTERLAVATORY&VESSELSINK(VC, VCM and VOV – 4 " height, VBE, VTP, VCR)
1. Install the basic plumbing components: water inlet and drain.
2. Determine where you will place your lavatory on the support surface/countertop, ensuring there
is adequate space for the waste pipe. Make an opening in the support surface/countertop.
(Figure 1)
3. Place the lavatory on the support surface/countertop, ensuring the waste pipe is in a clear position
and the lavatory in the desired spot. (Figure 2)
4. Mask the entire support surface/counter around the lavatory. (Figure 3)
This will protect the surface/countertop from the silicone sealer that will be applied on step 6.
5. Install the lavatory drain. Read the manufacturer’s instructions to ensure you are installing the
equipment as you should. Before the final installation phases, check that all connections are
waterproof.
To drill holes in the lavatory for installing the valving, see the section Tap drilling instructions annexed.
6. To fix the lavatory on the support surface/countertop:
 • Coverthelavatorysurfacesthatwillrestonthesupportsurface/countertopwithasilicone
sealer. (Figure 4)
 • Placethelavatoryonthesupportsurface/countertop.Pressdowntoensurethereisagood
adhesion between the 2 surfaces that are touching.
 • Removetheexcesssealer.
 • Removethemaskingtape.Letdryuntilthesiliconesealerhasset.
7. Connect all of the final plumbing. Hook up the water to the valving.
Figure 4
2
Figure 1
Figure 2 Figure 3
opening
for drain