Instruction Manual

6
ENGLISH INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
1. Using an Allen Wrench and 2 Leg
Screws and Lock Washers, attach the
Support Leg to the Lower Housing
(FIGURE A). The C-Clamp should be
facing inward.
2. Install the Chute to the Top
Housing using an Allen Wrench
and the 2 Chute Screws and Lock
Washers (FIGURE B).
3. Attach the Countertop Protector Pad
to the Support Leg (FIGURE C).
4. Open the C-Clamp by turn
the screw clockwise to open the
C-Clamp. Place the C-Clamp onto
the work surface, then turn the
screw counter-clockwise until rmly
tightened.
Chute
Top
Housing
FIGURE B
Chute Screws (2) &
Lock Washers (2)
Allen
Wrench
FIGURE A
Support Leg
Lower
Housing
Leg Screws (2)
&
Lock
Washers (2)
Allen
Wrench
Countertop
Protector
Pad
FIGURE C
Cut Hazard. Blades are sharp, use care when handling. The
use of cut-resistant gloves is suggested.
w WARNING
CLEANING INSTRUCTIONS
1. Thoroughly wash all parts in soapy water. Rinse with clean water. Dry all parts
immediately. NOTE: DO NOT immerse the Blade Assembly in sudsy water where
they cannot be seen. To prevent injury, keep the Blade Assembly visible at all
times.
2. Coat all metal parts with a food grade silicone spray.
HELPFUL HINT: A long, skinny brush is helpful when cleaning the Blade
Assembly.