Use and Care Manual

11
ENGLISH INSTRUCTIONS
1. Unplug from outlet.
2. Remove the Front Ring Nut, Grinding
Plate, Knife and Auger from the Grinder
Head before installing the Grinder Head
to the Main Body.
3. Align the notches on the Grinder Head
with the tabs on the Main body.
4. Insert the Grinder Head into the Main
Body and push the lever up to lock into
position (FIGURE F).
5. Insert the Auger into the Grinder Head,
(FIGURE G).
7.
Front Ring Nut and then onto the Grinder Head.
8. Turn the Front Ring Nut clockwise onto
the threaded end of the Grinder Head unti
tighten the Front Ring Nut.
9. Place the Tray on the upright part of
the Grinder Head. NEVER use the Grinder
without the Tray installed!
FIGURE F
FIGURE G
STUFFER ASSEMBLY
ENTANGLEMENT HAZARD: Disconnect power before
cleaning, disassembling or assembling.
!
WARNING
Auger
Driver
it touches the Stuffing Funnel. DO NOT over-
6. Place the Stuffing Spacer into the Grinder
Head. Make sure the notch of the Stuffing
Spacer fits into the positioning pin of the
Grinder Head.