Use and Care Guide

11
ENGLISH INSTRUCTIONS
GRINDING INSTRUCTIONS
1. Unplug from outlet.
2. Remove the Front Ring Nut, Grinding
Plate, Knife and Auger from the Grinder
Head before installing the Grinder Head
to the Main Body.
3. Align the notches on the Grinder Head
with the tabs on the Main body.
4. Insert the Grinder Head into the Main
Body and push the lever up to lock into
position (FIGURE F).
5. Insert the Auger into the Grinder Head,
Auger Driver end rst (FIGURE G).
6. Place the Stu󰀩ng Spacer onto the Auger
Pin. Make sure the positioning pins on
the Stu󰀩ng Spacer t into the notches
on the Grinder Head.
7. Insert the Stu󰀩ng Funnel through the
Ring Nut and then onto the Grinder
Head.
8. Turn the Ring Nut clockwise onto the
threaded end of the Grinder Head until
it touches the Stu󰀩ng Funnel. DO NOT
overtighten.
9. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder
without the Tray installed!
FIGURE F
FIGURE G
STUFFER ASSEMBLY
ENTANGLEMENT HAZARD: Disconnect power before
cleaning, disassembling or assembling.
!
WARNING
Auger
Driver End