Use and Care Manual

17
GRINDING TIPS
AUGER GRABBING STOMPER INSTRUCTIONS
To use the stomper to disassemble
the head of the meat grinder, follow
these instructions:
1. Unscrew the front ring nut.
2. Attach the handle end of the
stomper onto the auger pin. The
opening on the stomper should
completely secure around the
groove in the pin (FIGURE 14).
3. Pull the stomper toward yourself,
and away from the grinder. The
auger will begin to disengage from
the head of the grinder.
4. Use the hand that is not holding
the stomper to guide the auger out
from the head completely.
5. The auger, grinder knife and
plate are all now free from the head
and can be cleaned appropriately
(FIGURE 15).
WARNING! Before cleaning, assembling or disassembling the
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
FIGURE 14
NEVER operate Grinder without the
Tray/Safety Guard secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
W ARNING!
FIGURE 15
Stomper
Auger Pin
Front Ring Nut
Plate
Knife
Auger
Head
ENGLISH INSTRUCTIONS