Use and Care Guide

12
ENGLISH INSTRUCTIONS
STANDARD STUFFER ASSEMBLY INSTRUCTIONS
1. Insert the Head into the Gear
Housing with the feed chute of the
Head facing straight up. You will need
to line up the slot in the Head with the
Pin inside the Gear Housing. Be sure
the Head is seated fully into the Gear
Housing. (FIGURE 5)
2. Tighten the Head Locking Knob to
lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 6). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the Auger
Bearing for wear. If the Auger Bearing
has excessive wear, replace it to
prevent head damage.
4. Slide the Stufng Star over the
round portion of the Auger Pin.
5. Slide one of the Stufng Funnels
through the Flange and place it
through the Front Ring Nut.
6. Install the Front Ring Nut, DO
NOT OVERTIGHTEN. Turn the
Front Ring Nut until it makes contact
with the Flange, then make 1/4 turn
more to tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 7).
8. NEVER operate Grinder without the
Tray secured in place (FIGURE 7).
REFER TO “STUFFING
INSTRUCTIONS”
FIGURE 6
Head
Auger Bearing
Auger
Auger Splines
Auger Pin
Front Ring
Nut
Flange
Gear
Housing
Head
Slot in Head
FIGURE 5
Head Locking
Knob
Feed
Chute
FIGURE 7
Tray
Head
Feed
Chute
Neck
w WARNING
Cut Hazard. To avoid serious or fatal injury, never reach into
grinder feed chute. Always read instructions.
w WARNING
Electrical Shock Hazard. Disconnect power before
assembling.