Use and Care Guide

1. Follow the “Grinder Assembly
Instructions” to fully assemble the
Grinder including the Tray.
NOTE: It is best to grind the meat using
the coarse, 7 mm Grinding Plate rst.
If a ner grind of meat is desired, run
the coarse ground meat through the
Grinder a second time using the ne,
4.5 mm Grinding Plate.
2. Trim the meat of all cords, tendons,
bones, shot, etc.
3. For best results, be sure that all
meat has been chilled to between 32-
34
o
F (0-1
o
C) before grinding. DO NOT
ALLOW MEAT TO SIT OUT AT ROOM
TEMPERATURE LONGER THAN
ABSOLUTELY NEEDED. Closely
follow the “Food Safety” instructions as
outlined by the USDA.
4. Cut meat into sizes small enough to
t into the Feed Chute. Approximately
1” (2.5 cm) cubes.
5. Place cubed meat to be ground into
the Tray. Do not overll the Tray, place
just enough meat to leave the Feed
Chute area open.
6. Place a dish or bowl to collect the
ground meat at the end of the Grinder
Head (Figure 4).
7. Make sure the Grinder is in the
“OFF” position. Attach the Grinder to
the power supply.
8. Switch the Grinder to the forward
“FWD” position. Carefully start feeding
cubes of meat into the Feed Chute.
ONLY USE THE STOMPER TO
PUSH MEAT INTO THE HEAD, DO
NOT USE YOUR FINGERS OR ANY
OTHER OBJECT.
GRINDING INSTRUCTIONS
FIGURE 4
Tray
Stomper
Grinder
Head
Bowl for
ground meat
Motor
Cover
Feed
Chute
Gear
Housing
11
ENGLISH INSTRUCTIONS
w WARNING
Cut Hazard. To avoid serious or fatal injury, never reach
into grinder feed chute. Always use Stomper. Never operate without Tray in
place. Always read instructions.
w WARNING
Electrical Shock Hazard. Do not immerse cord, plug, or
motor in water or other liquid.
w CAUTION
Burn Hazard. The Gear Housing and the Motor Cover may
become HOT during operation. This is normal. DO NOT touch these parts during
operation or until they cool after use.