Use and Care Guide

PLEASE NOTE: This Grinder features an all-hardened steel gear

transmission. This causes the Grinder to operate at a higher volume and

temperature than other Grinders. This is normal and will not affect the

Grinder’s performance.

• DO NOT overtighten the Front Ring Nut. It should be rmly tight.

• Make sure the Grinding Knife blades lay at on the Grinder Plate.

• DO NOT operate the Grinder without meat in the Head. Running the Grinder while

dry could damage the Head and Auger.

• ALWAYS lubricate the Head, Grinding Plate, and Grinding Knife with a food-grade

silicone spray after cleaning.

If the Grinder Plate becomes jammed/clogged during operation, follow these steps

to restore normal output:

• Turn the Grinder “OFF” ( ) and disconnect the Power Cord from the electrical outlet.

• Remove the Front Ring Nut and Grinding Plate.

• Thoroughly clean the Grinding Plate. Make sure all of the holes are clear.

CAUTION

Cut Hazard. The grinding knife and plate can be sharp. Handle

with care.

• Reinstall the Grinding Plate and Front Ring Nut.

• Reconnect the Grinder to the electrical outlet.

• Continue with grinding.

• Repeat as necessary.

GRINDING TIPS

840303701 v15.indd 8 2/21/20 10:26 AM