Use and Care Guide

9
ENGLISH INSTRUCTIONS
1. Insert the Head into the Gear Housing with the Feed
Chute facing straight up. You will need to line up the
slot in the Head with the Pin inside the Gear Housing.
Be sure the Head is seated fully into the Gear Housing
(Figure 1).
2. Tighten the Head Locking Knob to lock the Head
into place.
3. Insert the Auger into the Head (Figure 2).
Align the Auger Splines with the Drive Shaft
of the Grinder.
4. Place the Knife onto the square
part of the Auger Pin (Figure 2).
Be sure the blades of the Knife
are facing outward.
5. Place one of the Grinder Plates
onto the Auger Pin; align the notch
in the Grinder Plate with the Pin in
the Grinder Head.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front Ring Nut
until it makes contact with the Grinder Plate,
then make 1/4 turn more to tighten
into place.
7. Insert the neck of the Tray into the Feed Chute
(FIGURE 3).
8. NEVER operate Grinder without the Tray
secured in place (FIGURE 3).
REFER TO “GRINDING INSTRUCTIONS”
GRINDER ASSEMBLY INSTRUCTIONS
Gear
Housing
Head
FIGURE 1
Head
Locking
Knob
FIGURE 2
Head
Auger
Auger Splines
Auger Pin
Grinder Plate
Front Ring
Nut
NOTE! Be sure the blades
of the Knife are facing out.
FIGURE 3
Tray
Head
Feed
Chute
w WARNING
Entanglement Hazard. To avoid serious or fatal injury,
never reach into grinder feed chute. Always use stomper. Never operate
without tray in place. Secure long hair and loose clothing before use.
Disconnect power before assembling. Always read instructions.
Knife