Use and Care Guide
1. Insert the Head into the Gear
Housing with the feed chute of the
Head facing straight up. You will need
to line up the slot in the Head with the
Pin inside the Gear Housing. Be sure
the Head is seated fully into the Gear
Housing. (FIGURE 5)
2. Tighten the Head Locking Knob to
lock the Head into place.
3. Insert the Auger into the Head
(FIGURE 6). Align the Auger Splines
with the Drive Shaft of the Grinder.
4. Slide the Stung Star over the
round portion of the Auger Pin.
5. Slide one of the Stung
Funnels through the Flange and
place it through the Front Ring
Nut.
6. Install the Front Ring Nut, DO
NOT OVERTIGHTEN. Turn the
Front Ring Nut until it makes
contact with the Flange, then
make 1/4 turn more to tighten into
place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 7).
8. NEVER operate Grinder without the
Tray secured in place (FIGURE 7).
REFER TO “STUFFING
INSTRUCTIONS”
11
ENGLISH INSTRUCTIONS
STANDARD STUFFER ASSEMBLY INSTRUCTIONS
FIGURE 6
Head
Auger
Auger Splines
Auger Pin
Front Ring
Nut
FIGURE 5
FIGURE 7
Flange
w WARNING
Entanglement Hazard. To avoid serious or fatal injury,
never reach into grinder feed chute. Always use stomper. Never operate
without tray in place. Secure long hair and loose clothing before use.
Disconnect power before assembling. Always read instructions.
Head
Feed
Chute
Neck
Tray
Slot in Head
Feed
Chute
Head
Gear Housing
Head Locking
Knob