Instruction manual

-8-
-17-
Disassemble the Grinder Head and wash each part thoroughly in warm
water, taking particular care to remove all grease and oil from surfaces. Dry
all parts thoroughly before re-assembling.
DO NOT IMMERSE THE MOTOR IN WATER OR OTHER LIQUIDS!
CLEANING INSTRUCTIONS
1. Remove the Head Assembly from the Grinder Motor.
2. Disassemble the Head Assembly.
3. Wash all parts that have come in contact with meat in hot soapy water. BE SURE
TO CLEAN IMMEDIATELY AFTER USE.
DO NOT IMMERSE THE MOTOR IN
WATER OR OTHER LIQUIDS!
4. Rinse the Grinder parts with clear hot water, then dry them IMMEDIATELY.
5. Fully lubricate the Head, Plates and the Knife with a food-grade silicone spray
before and after each use.
6. Clean the Motor Cover and Gear Housing with a damp towel and wipe dry.
DO
NOT IMMERSE THE MOTOR IN WATER OR OTHER LIQUIDS!
IMPORTANT: Any metal parts must be coated with a food-safe silicone spray to
prevent rusting; if not properly protected, these parts will begin to rust very quickly.
DO NOT use rusted parts. Ordering information can be found on the last page of
this instruction manual.
WARNING! Before cleaning, assembling or disassembling the Grinder,
make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!
ALWAYS unplug the Grinder when not in use.
PRIOR TO USE
8. Hold the casing in place with one hand while feeding the sausage mixture through
the Grinder. As the meat lls the casing, gently lay it on a clean, dry surface.
NOTE: When using natural casings, use a wet surface.
9. Do not ll the last 3”-4” (7.5-10 cm) of casing. After the entire length of casing has
been stuffed, twist the open end to close, then tie off the ends of the casing tightly to
close. Twist into links.
10. Whenever stufng sausage, ll the casing slowly to avoid air pockets. If air pockets
do appear in the sausage use a pin to prick the bubbles. The small holes will seal
naturally.
NEVER operate Grinder without the
Tray secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
WARNING!
NEVER operate Grinder without the
Tray secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
WARNING!
.
Allow the Grinder Motor to come to a COMPLETE
STOP before engaging into reverse “REV”
(Figure 15).
.
Allow the Grinder Motor to come to a COMPLETE
STOP before engaging in forward “FWD” after using the
reverse function.
.
NEVER operate the Grinder in reverse for more than 5
seconds at a time.
REVERSE FUNCTION
(Only equipped on#22 & #32 Grinders)
On/Off/Reverse
Power
Switch
FIGURE 15