Use and Care Guide

6
ENGLISH INSTRUCTIONS
1. Apply a few drops of vegetable oil to the
rubber Drive Shaft O-Ring (3).
2. Ensure the Drive Shaft Clip (4) and Drive
Shaft O-Ring seal (3) are in place on the
drive shaft. NOTE: This conguration is
pre-assembled on rst use (5). FIGURE A
3. Insert the Screen Gasket (18) into the
large end of the Screen (15), making sure
the Gasket is under the Thumbscrew (11).
FIGURE B
4. Slide the red plastic Spiral (9) onto the
Drive Shaft (5) over the Spring (14). Be
sure to match the ats on the Drive Shaft
to the metal insert in the side of the Spiral.
FIGURE C
5. Align the notches of the Body (2) with
the notches in the Multi-Purpose Screen
(15). FIGURE D
6. Holding the Body rmly in one hand,
push the Multi-Purpose Screen (15) over
the Spiral (9) and Drive Shaft Assembly
(5) and compress, then turn 1/8th of a
turn counter-clockwise to lock it in place.
(NOTE: The “ON” - “OFF” direction arrows
are on the base of the Multi-Purpose
Screen.)
7. Tighten the Screen Thumbscrew (11)
to lock the Screen in place (NOTE: Finger
tighten only, do not over tighten). FIGURE
E
NOTE: Operating the Tomato Press
& Sauce Maker while empty is NOT
recommended. The juice from the fruits
and vegetables act as a lubricant for the
mechanisms and reduce wear on the
components.
FIGURE C
FIGURE D
FIGURE B
FIGURE A
FIGURE E
ASSEMBLY INSTRUCTIONS
4
5
14
3
15
18
11
9
14
5
2
15
11