Use and Care Manual

5
ENGLISH INSTRUCTIONS
5 4 3 2 1
ASSEMBLY INSTRUCTIONS
1. Place the Slider Handle onto
the center of the Base. Making
sure the top side (raised edge of
the Handle) of the Slider Handle
is facing up (FIGURE 1).
2. Place the Clear Acrylic Top
Plate on top of the Base, lining
up the holes in the Clear Acrylic
Top Plate with the corresponding
holes on the Base.
3. Insert and tighten the 3
Locking Knobs to hold the Clear
Acrylic Top Plate in place. DO
NOT OVERTIGHTEN THE
LOCKING KNOBS. DO NOT
USE TOOLS TO TIGHTEN THE
LOCKING KNOBS.
4. Find the Funnel that ts the
grinder/stuffer that is to be used.
5. Slide the front ring nut of the
grinder/stuffer over the Funnel
(FIGURE 2).
6. Keeping the notch side
down on the Funnel, attach the
Funnel to the grinder/stuffer by
tightening on the front ring nut to
the head of the grinder/stuffer.
DO NOT OVERTIGHTEN.
NOTE: If you are using a grinder
be sure that either the stufng
star or spacer is in place or the
knife and cutting plate is in place.
7. Align the notch of the Funnel
with the groove of the Base and
slide the Funnel into the Base.
8. Insert and tighten the Locking
Knob on the bottom of the Base
to hold the Funnel in place. DO
NOT OVERTIGHTEN THE
LOCKING KNOB. DO NOT
USE TOOLS TO TIGHTEN THE
LOCKING KNOB.
Be sure to follow ALL SAFETY
WARNINGS and precautions
that are contained in this
instruction manual before
using this appliance!
Always use the stomper to
push meat or other
foods into the grinder.
DO NOT USE FINGERS or
anything but the stomper for
pushing meat/food
into grinder!
Never leave this appliance
unattended!
WARNING!
FIGURE 1
FIGURE 2
Base
Clear
Acrylic
Top Plate
Slider Handle
Locking
Knobs
Raised Edge
Up
Locking
Knob
Base
Funnel
Notch Side Down
Front Ring Nut from
Grinder/Stuffer
Clear
Acrylic
Top Plate
Slider Handle