User Manual

Install last part of Cushion Seat (B) by using CSK Screw (H) as shown below. Tighten

all sections from previous steps by using Screwdriver (not included).

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean

surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over

time. Periodically check that all connections are tight.

Stand the chair up on even surface and check that it is balanced. If there is a slight wobble, apply

downward pressure in the corner where a leg is uneven. Keeping pressure in that corner, tighten

all bolts. If balanced, apply downward pressure evenly in the center and tighten all bolts. Do not

over-tighten beyond hole depth.

Helpful Tip:

-Instead of applying downward pressuere

while reaching under to tighten bolts, have

someone sit in the chair while you tighten

the bolts.