ASSEMBLY INSTRUCTION 530C4-29 NAPOLEON BACK 29"H BAR HEIGHT CHAIR Chair Back E Box Frame Wooden Seat m Front Leg {Left-Right) 1pc 1pc 1pc PCs Side Stretcher (Long) Front Stretcher (Short) Hebe Bolt | H R (Left-Right} M8 x 70mm M8 x 40mm apes 1pc PCs PCs "Lock Washer Flat Washer Cs-Ch Screw Pan Head Screw M6 M6 #3x1* #x 112" E Do (oo pests pests Bps Bps Allen Key m Glue M4 x 60mm 1pc pc This page lists all the contents included in the box.
Box Frame (B) onto Chair Back (A). Then insert Hebe Bolt (G), Lock Washer (1) and Flat Washer (J) into prevailed holes of each corner by using Allen Key (M). Insert Hebe Bolt (H), Lock Washer (1) and Flat Washer (J} into the prevailed holes of the middle of Chair Back {A) by using Allen Key {M}. Do not fully tighten the bolts in this step. Put the Chair Back (A), Box Frame (B) upside down on the soft and smooth surface. With assistance attach Take the Allen Key, and turn the bolts until the legs are secure.
Attach Front Leg (D) assembly to corner of Box Frame (B) along inserting the Front Stretcher (F) onto each hole on Front Leg (D) with applying some Glue (N}, then insert Job Bolt (G), Lock Washer (1) and Flat Washer (J) using Allen Key (M). Insert Pan Head Screw (L) into the holes of Front Leg (D) and Stretcher (F) by using screwdriver (not included).
Attach Wooden Seat (C) and Box Frame {B) with Cs-Cb Screw (K) by using screwdriver (not included). Tighten all screws in this step. 6 Turn the assembled chair to the upright position carefully. Make sure the chair is level, and then securely tighten all bolts at this stage. Assembly is now completed. Stand chair up on an even surface and check that it is balanced. If there is a slight wobble, apply downward pressure in the corner where a leg is uneven. Keeping pressure in that comer, tighten all bolts.
