ASSEMBLY INSTRUCTION 530C3-29 DOUBLE X-BACK 29"H BAR HEIGHT CHAIR air Bac ox Frame wooden Seat rot Leg (Left-Right, I chair Back Box Front Leg (Left-Right 1pe 1pc PCs Side Stretcher (Long) Front Stretcher (Short) Hebe Lott Hebe Bolt (Le-Right) M6 x 70mm M8 x 40mm PCs 1pc PCs PCs Lock Washer WY Fiat Washer i Cs-Cb Screw [ Pan Head Screw ISMS PCs PCs PCs Apes Mane Key m Glue M4 x 60mm 1pc ipe This page lists all the contents included in the box.
1 Put the Chair Back {A), Box Frame (B) upside down on the soft and smooth surface. With assistance attach Box Frame (B} onto Chair Back (A). Then insert Jibe Bolt {G), Lock Washer (1) and Flat Washer (J) into prevailed holes of each corner by using Allen Key (M). Insert Hebe Bolt (H), Lock Washer () and Flat Washer (J} into the per-drilled holes of the middle of Chair Back (A) by using Allen Key (M). Do not fully tighten the bolts in this step.
Attach Front Leg (D) assembly to corner of Box Frame (B} along inserting the Front Stretcher (F) onto each hole on Front Leg (D) with applying same Glue {N), then insert Hebe Bolt (G}, Lock Washer (1) and Flat Washer (J) using Allen Key (M). Insert Pan Head Screw (L} into the holes of Front Leg (D) and Stretcher (F) by using screw driver (not included).
. Attach Wooden Seat (C) and Box Frame {B) with Cs-Cb Screw (K) by using Screwdriver (not included). Tighten ail screws in this step. E‘ Turn the assembled chair to the upright position carefully. Make sure the chair is level,and then securely ) tighten all bolts at this stage. Assembly is now completed. Stand chair up on an even surface and check that iris balanced. If there is a slight wobble, apply downward pressure in the comer where a leg is uneven. Keeping pressure in that corner, tighten all bolts.
