ASSEMBLY INSTRUCTION 530 13 (3A) DINING BENCH WITH TRESTLE LEG TN WOODEN SEAT TRESTLE LEG BASE TRESTLE BAR 1PC 2 PCS PCS 1PC BI SUPPORT BAR ALLEN WRENCH CBC M6 x 35tmm CBC M6 x 70mm (Unloose from step 1) (Included 4 pcs from step 1) <> PCS 1PC 16 PCS 12 PCS WHISPERING WASHER M6 INFLATE WASHER M6 PVC DOWEL M8 x 30mm WOOD BUTTON (Included 4 pes from step 1) (Included 4 pes from step PCS 8ยง PCS 2 PCS PCS This Page lists all the contents included in the box .
Please unloose bolt, spring washer and flat washer from support bar(E) with Allen wrench(F). Keep the hardware for step 5 and support bar for step 2 use. Align and fasten support bar(E) to trestle leg(B) using short bolt(G) and spring washer(l) which unloose from step 1 and tighten with Allen wrench(F). ** Do not fully tighten the nut or bolt until all nuts and bolts are attached.
i) Insert pve dowel(K) to both end of trestle bar(D). ii) Align and fasten trestle bar(D) to trestle leg(B) using long bolt(H) and spring washer(I) and tighten with Allen wrench(F). Insert wood button(L) to cover the open hole of the leg. DS Flip bench leg over, align and fasten bottom base(C) to trestle leg(B) using long bolt(H) and spring washer(I). Tighten bolts with Allen wrench(F). ** Do not fully tighten the nut or bolt until all nuts and bolts are attached.
Place wooden seat upside down on soft surface. Align and fasten support bar(E) to wooden seat(A) using short bolt(G), spring washer(l) and flat washer(J) and tighten with Allen wrench(F). ** Do not fully tighten the nut or bolt until all nuts and bolts are attached. Cleaning & Care Treat Surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a dry or damp soft cloth. Do not use abrasive cleaners . Hardware may loosen over time.
