User Manual

Place the Seat (B) upside down on the smooth carpet surface. Attach the Front Leg (C) to Seat (B)

by Bolt (G), Lock Washer (I) and Flat Washer (J) with Allen Wrench (K).

Place the Chair Back (A) with Seat (B) on smooth carpet surface. Attach the Chair Back (A) with

Seat (B) by Bolt (H), Lock Washer (I) and Flat Washer (J) with Allen Wrench (K). Then tighten Chair

Back (A) and Seat (B) by Bolt (D), Lock Washer (E) and Flat Washer (F) with Allen Wrench (K).

Take the Allen Wrench, and turn the

bolts until the legs are secured. DO NOT

TIGHTEN COMPLETELY. Stop when

you feel you are adding force to tighten

the bolt.

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry

or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all

connections are tight.

Stand chair up on an even surface and check

that it is balanced. If there is a slight wobble,

apply downward pressure in the corner where

a leg is uneven. Keeping pressure in that

corner, tighten all bolts. If balanced, apply

downward pressure evenly in the center and

tighten all bolts. Do not over-tighten beyond

hole depth.

Helpful Tip：

-Instead of applying downward pressure while

reaching under to tighten bolts, have someone

sit in the chair while you tighten the bolt.