User Manual

Attach Leg Support (C) to Table Top (A) using Bolt (D) with Allen Key (F).

Attach Bottom Frame (B) to Leg Support (C) using Bolt (E) with Allen Key (F).

Adjust Pre-installed Levelers

height to achieve balance.

Adjust the Pre-installed Levelers at the Bottom Frame (B) until the End Table is level

with the ground.

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean

surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen

over time. Periodically check that all connections are tight.

Cleaning & Care

Note: At this stage, do not fully tighten the Bolts.

Note: At this stage, tighten all Bolts at all joints fully in a sequential manner.