Specifications

WESTLOCK CONTROLS CORPORATION
280 N. MIDLAND AVE., STE. 258, SADDLE BROOK, NJ 07663 TEL: [phone] FAX: [phone]
westlockcontrols.com
4/7/10 TECH-382/D.W.O. 17072 Page 10 of 15
Switch Adjustment (four switches, no CS transmitter):
Follow steps as above for the calibration of two switches but adjust the first
and third cams from the top for switches #1 and #2 and the second and fourth
cams from the top for switches #3 and #4 (see illustration below).
TOP & 3RD CAM
TOP & 3RD CAM
PUSH DOWN, TURN
PUSH DOWN, TURN
& RELEASE
& RELEASE
MAGNUM
MAGNUM
PROXIMITY
PROXIMITY
SWITCH
SWITCH
MECHANICAL
MECHANICAL
SWITCH
SWITCH
iNDUCTIVE
iNDUCTIVE
PROXIMITY
PROXIMITY
SENSOR
SENSOR
2ND & BOTTOM CAM
2ND & BOTTOM CAM
LIFT UP, TURN
LIFT UP, TURN
& RELEASE
& RELEASE
Transmitter setting (optional CS transmitter):
For the calibration of optional current signal (CS) transmitter, see Westlock
Controls Installation/Operations Manual TECH-301, available through your
local sales representative or at westlockcontrols.com.
Beacon Adjustment:
Note: Skip this step if cover is flat or Beacon already displays the correct
valve status.
Required Tools: slotted screw driver for #12 screws.
1. For two-way OPEN/CLOSED: remove, rotate and re-fasten outer beacon
to synchronize displayed position with valve position.
2. For three-way flow paths: remove, rotate and re-fasten outer beacon
and/or inner beacon coupler to synchronize displayed flow path with
valve/actuator flow path.
For the 360 and 366 models:
Required Tools: set screw driver for M4 set screws and snap ring tool.
1. Remove shaft snap ring and inner beacon.
2. Disengage set screws from outer beacon, rotate and re-fasten outer and
inner beacon to synchronize displayed position with valve position.
OPEN
OPEN
OPEN
Valve in
Position
CLOSED
CLOSED
CLOSED
Valve in
Position