Specifications

WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: [phone] FAX: [phone]
www.westlockcontrols.com
1/12/10 TECH-439/D.W.O. 19024 Page 6 of 58
The ICoT is available in two versions, HART® and non-HART. The non-HART
version allows calibration of the instrument through an on board keypad. The
HART® version allows calibration and access to on-line diagnostic information via
Rosemount 275/375 hand-held terminal or through software.
The positioner has a local liquid crystal display which indicates valve position and
set-point in percentage of full span. It also indicates whether the positioner is in
calibration mode.
The ICoT has the capability to monitor operation. If a failure condition occurs, an
error message is displayed on the local liquid crystal display.
There are several accessories that can be integrally supplied with the ICoT.
Among these are a 4 to 20 mA analog output, and a set of hermetically sealed
non-contact limit switches.