Specifications

WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: [phone] FAX: [phone]
www.westlockcontrols.com
1/12/10 TECH-439/D.W.O. 19024 Page 26 of 58
4.3 Proceed to Exiting Calibration or Perform Advanced Calibration
After the completion of an Automatic Calibration (ACAL) the calibration of the positioner
is complete. The Automatic Calibration that was performed in Section 3 is adequate for
most applications. If no advanced calibration is required proceed to Section 5 to exit
calibration. If the user requires using the advanced settings to fine tune the positioner
he may proceed with the remainder of this step and perform adjustments and
calibrations in the Manual Calibration Menu (MCAL). From the menu level press the
down arrow button until MCAL is shown on the display (MCAL Routine shown below).