Specifications

WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: [phone] FAX: [phone]
www.westlockcontrols.com
1/12/10 TECH-439/D.W.O. 19024 Page 24 of 58
4 Calibration
The ICoT positioner has an on-board menu structure that can be accessed by pressing
the Cal button. Exit any function by pressing both up and down arrow buttons
simultaneously, anytime during calibration.
4.1 Enter Calibration (Menu Level)
Enter the calibration menu by pushing the CAL button. ACAL (Auto Cal Menu) is the
first of four menus. By pressing the CAL button again you enter go to a lower level
menu or start a routine. Pushing the down arrow button you can cycle through the
menus. The remaining three menus are MCAL (Manual Cal Menu), Cofg (Configuration
Menu), Stro (Manual Position Override Menu). Pushing the up arrow you exit the menu
or go to an upper level menu. The menu level is shown below.