Specifications

WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: [phone] FAX: [phone]
www.westlockcontrols.com
1/12/10 TECH-439/D.W.O. 19024 Page 18 of 58
Figure 3-8
To Center the Positioner
1. Stroke the actuator to its upper limit and place a mark on the actuator’s yoke that
lines up with the red arrow on the magnet assembly.
2. Stroke the actuator to its lower limit and place a mark on the actuator’s yoke that
lines up with the red arrow on the magnet assembly.
3. Place a third mark on the yoke centered between the upper and lower limit
marks.
4. Lastly, mount the positioner to the bracket so that the positioner sensor (nose) of
the ICoT lines up with the midpoint mark. (See Figure 3-8).