Specifications

WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: [phone] FAX: [phone]
www.westlockcontrols.com
1/12/10 TECH-439/D.W.O. 19024 Page 14 of 58
Step 4. Mount positioner at a remote location.
Step 5. Remove the electronic canister cover by unscrewing (2) mounting screws.
(Appendix B: Procedure to Remove Electronics Cover and Electronic Canister)
Step 6. If necessary cut remote cable to required length, making sure to cut end
opposite female connector. Wire the positioner sensor back to the positioner using the
cable provided and replace cover. (See Figure 3-4).
Figure 3-4