User Manual

50
during the pyrolytic cleaning process. It is strongly
advised to remove any pets (especially birds) from
the vicinity of the appliance during and after each
pyrolytic cleaning process.
• Small pets can also be highly sensitive to the
localized temperature changes in the vicinity of all
pyrolytic ovens when the pyrolytic self cleaning
program is in operation.
WARNING
CAUTION
• All accessories must be removed from the oven,
including shelves, trays and side racks.
• During pyrolytic cleaning the air outlet vent above
the door must be kept clear of any obstruction (e.g.
tea towels).
• Do not use your oven to clean miscellaneous items
(e.g. cookware).
• To prevent damage, do not use acids, sprays or
similar cleaning agents.
TIPS & INFORMATION
IMPORTANT
During the pyrolytic cleaning function, it is advisable
not to use a cooktop if it is fitted above the oven. This
could cause overheating and damage to both appliances.
The cooling fan will operate at an increased speed for
pyrolytic cleaning and will continue to run until the oven
has cooled down. It is recommended to use the Pyro
clean function regularly to keep the oven in its
best condition.
Starting the Pyrolytic cleaning function
(WVEP615, WVEP617 & WVEP627 models only)
• Make sure all accessories are removed from the oven
including shelves, trays and side racks.
• Turn the oven “Function” selector clockwise to select
the “Pyro” position.
• Use the
or buttons on the electronic clock to
select between a pyrolytic cleaning time of 1:30 hours
(light clean) or 2:30 hours (normal clean) for the
appropriate level of cleaning.
• After 5 seconds from the last change, the oven
will begin heating and the “Remaining time” will
be displayed.
• The pyrolytic cleaning function can be stopped at any
time during the cycle by turning the function selector
counter-clockwise to the “OFF” position.
NOTE: The “Remaining time” does not include cool-down
time for the oven.
NOTE: The bottom oven does not have the pyrolytic
cleaning function.
Starting the pyrolytic cleaning function
(WVEP618 models only)
Refer to the Pyrolytic cleaning (WVEP618 model only)
section on page 25.
During Pyrolytic cleaning
When the temperature in the oven approaches 300˚C,
the door will automatically lock and a padlock symbol will
appear on the display.
After Pyrolytic cleaning
The door will only unlock when the oven has cooled to a
safe temperature. Turning the function off will not unlock
the door.
After cool-down, wipe the ash out of the oven with a soft
damp cloth and warm water. To restore the enamel shine
to more difficult areas, use a damp cloth with vinegar
and detergent.
WARNING
CAUTION
Do not turn off the mains power supply to the oven
during the pyrolytic cleaning cycle. This could damage
the appliance.
Cleaning the cavity well
The cleaning procedure removes limestone residue from
the cavity well after cooking with steam.
WARNING
WARNING
Perform the cleaning procedure at least every 5
EasyBake + Steam cooking cycles.
1. Mix 150ml of tap water with 100ml of white vinegar
and put the mix in the cavity well.
2. Let the water and vinegar mix dissolve the limestone
residue at the ambient temperature for 45 minutes.
3. Remove the water and vinegar mix with a soft cloth
and clean the cavity with warm water and a soft
cloth.
Cleaning steam parts (WVEP618 model only)
SUBMENU APPLICATION
Descaling
Procedure for cleaning the steam
generation circuit from residual
limestone.
Rinsing
Procedure for rinsing and cleaning
the steam generation circuit after
frequent use of the steam functions.
Tank emptying Procedure for removing the residual
water from the water drawer after use
of the steam functions.
CARE AND CLEANING (CONTINUED)
CARE AND CLEANING