User Manual

29USING YOUR OVEN
Before first use
Initial cleaning
Remove all accessories and removable shelf supports
from the oven.
Refer to “Care and cleaning” chapter.
Clean the oven and the accessories before first use. After
cleaning, put the accessories and the removable shelf
supports back to their initial position.
First connection
When you connect the oven to the mains or after the
power is cut, you have to set the display contrast, the
display brightness and the time of the day.
1. Press
or to set the value
2. Press OK to confirm
Setting the water hardness for WVEP618 model
The table below shows the water hardness range (dH)
with the corresponding Calcium deposit and the quality
of the water. Contact your local water supplier to set the
water hardness level or as an alternate set the default
value at level 4 (Water hardness function is in Basic
Settings menu). If the water hardness exceeds the values
in the table, fill the water drawer with bottled water.
Water
hardness
Calcium
deposit
(mmol/l)
Calcium
deposit
(mg/l)
Water
classification
Class dH
1 0-7 0-1.3 0-50 Soft
2 7-14 1.3-2.5 50-100
Moderately
hard
3 14-21 2.5-3.8 100-150 Hard
4 over 21 over 3.8 over 150 Very hard
Preheating before first use
New appliances can have an odour during first use. It is
recommended to ‘run in’ the oven before cooking for the
first time. Operate the oven(s), empty. Set the function to
“Fan Bake” at a temperature of 180°C for approximately
30 minutes.
Please ensure that the room is well ventilated during this
process.
Daily Use
Navigating the menus
1. Turn on the oven
2. Press
or to select the menu option
3. Press OK to move to the submenu or accept the
setting
TIPS & INFORMATION
At each point you can go back to the main menu
with