User Manual

44 45INSTALLATION
INSTALLING YOUR APPLIANCE
Non-pyrolytic underbench ovens and side open door oven
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
Power point connection for the WVE617 must be accessible with the appliance fully installed. If the supply cord is
damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
a hazard.
A B C
Flush fit 600 600 581min
Proud fit 565 590 560min
C
B
A
558
596
mounting
holes
use long black
installation
screws
upper infill
(if required)
Separate grill underbench oven
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
NOTE TO INSTALLER: For separate grill underbench installations where a cooktop is installed directly above the
appliance, a minimum clearance distance of 10mm must be allowed for between the bottom of the cooktop & the top
of the separate grill underbench oven.
A B C
Flush fit 600 731 581min
Proud fit 565 723 560min
C
B
A
561
mounting
holes
use long black
installation
screws supplied
Separate grill wall oven & duo oven
WARNING
CAUTION
NOTE: Dimension “D”.
A requirement for all separate grill wall ovens and all duo ovens – for proper ventilation there must be a gap at the
bottom rear of the cabinet. This can be a full width opening 20mm deep.
A B C D
Flush fit 600 893 581min 20
Proud fit 565 885 560min 20
D
B
A
C
561
596
650mm
min
mounting
holes
use long black
installation screws
supplied
Pyrolytic underbench oven
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
WARNING
CAUTION
NOTE: Dimension “D”.
A requirement for all pyrolytic clean ovens – for proper ventilation there must be a gap at the bottom rear of the
cabinet. This can be a full width opening 20mm deep.
C
B
A
558
mounting
holes
596
upper infill
(if required)
use long black
installation
screws
D
GAS TYPE
A B C D
Flush fit 600 600 581min 20
Proud fit 565 590 560min 20
INSTALLATION