Quick Start Guide

Condition the oven (to burn o any residue)
New appliances can have oil or residue left
from manufacturing. You will need to heat
your oven for 30 minutes before using it for
the first time.
1. Turn the function selector dial to FAN
FORCED
2. Using the temperature selector, set the
oven at 180°C for approximately 30
minutes. Please ensure that the room is well
ventilated during this process.
Set the time
You must set the time before you can operate
your appliance.
1. When power is supplied to the oven, the
clock icon will be displayed. Along with the
clock symbol the “12” will be flashing.
This indicates that the “hour” portion of the
time is ready to be changed.
2. Toggle the temperature selector
or , then
touch when you have the right hour.
3. The minutes will flash and can be set in
the same manner. 5 seconds after the last
change, the clock display will stop flashing,
confirming that the time has been set.
NOTE: The clock has a 24 hour display.
655
645
636
617
625
616
615
614
613SC
665
P615
P617
P618
P627
FUNCTION TEMP
Hold 3s
BACK FAVOURITE
SET TIME
ALARM OK
ON/OFF
16:30
00:15 140°C
Installing the oven accessories
1. Install telescopic slides (where supplied) to the
side racks. Refer to installation guide supplied
with oven slides.
2. Insert side racks
There is a left hand and right hand version (see image).
1. Insert the rear peg into the rear access hole,
ensuring that the peg is fully inserted.
2. Then locate the front peg into the front access hole
and push in firmly.
Set...
4. Fit shelf/tray (where
supplied) to telescopic slides
1. Push the shelf or tray along
the top of the slide until it hits
the back post.
Shelf
Back post
2. Drop the front of the shelf or
tray onto the slide ensuring it
sits behind the front post of the
slide.
Shelf
Front post
3. When fully inserted the shelf/
tray should not interfere with the
closed oven door.
3. To fit a shelf or tray to side racks:
1. Locate the rear edge of the shelf
in between guide rails of the
side rack. Ensure the same rail
positions on both sides of the
oven are being engaged.
2. With the front edge raised, slide
the shelf into the oven.
3. Once the detents have passed the
front edge of the side rack, the
shelf can be pushed completely in.
Detent
Left hand side rack
front peg rear peg