User Manual

ManualsBrandsWestinghouse ManualsAll Ovens60cm Electric Built-In Oven

6 INSTALLING YOUR APPLIANCE

• If a powerpoint is fitted it must be accessible with the

appliance installed, as the plug must be accessible

after installation.

• This appliance must be mounted on a flat surface for

the full width and depth of the product.

• To avoid overheating, the appliance must not

be installed in a recess or cupboard behind a

decorative door.

Hard wiring detail

1. Remove terminal cover plate from rear panel

of appliance.

2. Fit wires through hole in cover plate and make

connections to terminals.

3. Engage wires into plastic clip. Secure plastic clip with

two long silver screws (supplied in separate bag).

4. Replace cover plate onto rear panel.

553mm

15mm

8mm min

clearance

Second active wire only

required (optional) for

multi-phase products

Plastic clips

Plastic clip

securing points

Cabinet construction for your appliance

For the best integration within a kitchen, in stall this

appliance in a standard 600mm wide cupboard that

gives a flush fit (FigureA) with the surrounding cupboard

fronts. Appliances can also be installed using a proud fit

(Figure B).

WARNING

CAUTION

For all Pyrolytic clean models, the “infill panel” MUST

not exceed 100mm in length. This ensures a 16mm

gap is maintained between the cabinet and side of the

appliance to prevent the cupboard overheating. Cabinet

must be minimum 600mm width.

Fig. A

Flush Fit

16mm

568mm

600mm

20mm

Infill

panel

Cupboard

door

Oven

100mm max

for Pyro

oven

Fig. B

Proud Fit