Use and Care Manual

16
|
English
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTION
Snow blower won’t
start
Snow blower is not plugged in. Connect snow blower to 120V power
supply. Be sure the snow blower plug is
properly connected to the extension cord.
The start button was not depressed. Press and hold the start button before
engaging the bale.
The motor is on but the
auger does not turn.
The drive belt may be worn or broken. Replace the drive belt.
A layer of snow
remains on the ground
after passing over it.
The auger or scraper may be worn. Have the auger or scraper replaced by an
authorized service center.