User manual

DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to “Setting and
starting a program”.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct program for
the type of load and the degree of soil.
USING THE DETERGENT
20
30
M
A
X
1
2
3
4
+
-
A
B
C
Caution! Only use detergent for dish-
washer. Other products can cause
damage to the appliance.
Do not use more than the correct
quantity of detergent. Refer to the in-
structions on the detergent packaging.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the program has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Detergent tablets do not fully dissolve with
short programs. To prevent detergent resi-
dues on the tableware, we recommend
that you use the tablets with long pro-
grams.
Use of multi-tablets
These products are detergents with com-
bined cleaning and rinsing functions. They
can contain also other cleaning agents.
Refer to the instructions from the manufac-
turer for the use of these products.
When you use tablets that contain rinse
aid:
• Set the lowest position for the rinse aid
dosage.
• Do not put rinse aid in the rinse aid dis-
penser. In this condition the rinse aid indi-
cator is always on.
Follow these steps if the drying results
are not satisfactory or you want to use
normal detergents again
1. Fill the rinse aid dispenser with rinse aid.
2. Adjust the rinse aid dosage.
SETTING AND STARTING A PROGRAM
The AUTO OFF function
To decrease the energy consumption, this
function automatically deactivates the appli-
ance a few minutes after:
• You have not closed the door.
• You have not pressed START to start
the program.
• The program is completed.
Setting mode
To start a program it is necessary that the
appliance is in setting mode.
westinghouse 11