User manual

INSTALLATION
FITTING UNDER A KITCHEN COUNTER
The plinth of a freestanding appliance is not
adjustable.
Do not remove the appliance worktop if you
want to use it as a freestanding unit.
It is not necessary to remove the worktop
when installing under a standard kitchen
counter.
Only remove the appliance worktop to in-
stall it under a close fitting sink unit or kitch-
en counter (820 mm).
min 570 mm
600 mm
820 mm
1. Put the appliance adjacent to a
water tap and a water drain.
2. Make sure that the dimensions
of the recess agree with the di-
mensions in the figure.
Removing the worktop
4
3
2
1
3. Remove the rear screws (1).
4. Pull the worktop from behind
(2).
5. Lift the worktop and move it
from the front slots. (3)
6. Level the appliance using the
adjustable feet.
7. Install the appliance under the
kitchen counter.
Adjusting the level of the appliance
A correct adjustment of the level of the ap-
pliance allows the door to close and seal
correctly.
If the door does not close correctly, loosen
or tighten the adjustable feet to level the ap-
pliance.
WATER CONNECTION
Water inlet hose
Connect the inlet hose to a water tap with
an external BSP thread spout of 3/4″.
For best washing performance it is recom-
mended to connect the appliance to a cold
water supply.
Energy savings can be made by connecting
the appliance to a Solar water system and
16 westinghouse