User Manual

7ICE & WATER INSTALLATION
3. Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level. You can
adjust the level as detailed in step 2.
4. If you find your refrigerator rocks from corner to
corner, it means your floor is uneven. Find a piece
of plastic or hardboard etc. and pack it firmly under
the foot.
5. You may now need to fine-tune the installation by
repeating steps 2, 3 and 4.
6. Plug your refrigerator straight into its own power
point and never use a double adapter.
7. Before you put any food in your refrigerator, it’s
recommended you leave it on for 2 or 3 hours to
check it is running properly.
Fitting the handles
The handles are supplied prepackaged inside your
refrigerator and will require fitting. Refer to the
instructions provided in the pack.
WARNING
WARNING
Connect to potable water supply only.
The new hose-sets supplied with the appliance must be
used and old hose-sets should not be reused.
Never connect the appliance to a hot water supply.
Do not use with water that is microbiologically unsafe
or with water of unknown quality without adequate
disenfection.
Water Filter
The service life of the filter may be reduced in water
supplies that contain an excess of particles or other
impurities. Reduced flow rate is an indication that a new
filter is required. Failure to replace the filter when required
can affect the function of the ice maker. Service calls
caused by a failure to replace the filter are not covered
by warranty. Replacement water filters are available from
Electrolux Home Products Spare Parts Centres and can
be posted to you for your convenience (refer to spare
parts contact numbers on the warranty page).
Contents of installation kit
4 metres of water tubing
DATE FITTED___/___/___
1 x 1/2” tap fitting
Water supply and plumbing
A drinkable water supply to suit a 1/2” tap fitting is
required adjacent to the refrigerator. It is recommended
that a licensed plumber install a new water supply outlet
nearer to the appliance should the tubing supplied not be
long enough. It is not recommended that the tubing be
extended as this could adversely affect the flow of water
to the ice maker or water dispenser. The water dispenser
and automatic ice maker require a drinkable water supply
with a pressure range of between 206kPa and 689kPa
(30PSI and 100PSI). If the water supply is above 100psi a
pressure limiting valve should be installed.
It is recommended that a noise reduction valve also be
fitted in the water supply line. This will reduce water
hammer and its effects from quick action household taps
and fast acting valves on appliances.
The refrigerator water valve is pre-fitted with a push-fit
connector for inserting the water tube. When the tap
connection is other than 1/2”, adapters can be purchased
from plumbing supply stores or good hardware stores.
ICE AND WATER INSTALLATION
Adjust front feet for unevenness
of floor e.g. adjust this foot
down. Packing may be required
underneath the rear roller to
ensure stability.
Top of refigerator is
level – horizontal
Aligned to cupboard
– even gap
Centre roller