Installation guide

WHIRLPOOL CORPORATION  TRAINING
Changing the Water Filter
 94
 1. Locate the water filter in the top-right corner of the refrigerator compartment.
 2. Lift open the filter cover door. The filter will be released and then eject as the door is opened.
 3. When the door is completely open, pull the filter straight out..”
 NOTE: There may be some water in the filter.
 Some spilling may occur.
 Use a towel to wipe up any spills.
 4. Take the new filter out of its packaging and remove the
covers from the O-rings. Be sure the O-rings are still in place
after the covers are removed.
 5. With the arrow pointing up, align the new filter with the
filter housing and slide it into place.
 The filter cover door will automatically begin to close as the
new filter is inserted.
 6. Close the filter cover door completely in order to snap the
filter into place. You may need to press hard.
 7. Flush the water system until a total of 3 gal. (12 L) has been
dispensed. See “Water and Ice Dispensers.”