Installation guide

WHIRLPOOL CORPORATION  TRAINING

The Ice Dispenser

 88

To Dispense Ice:

1. Make sure the desired type of ice is selected.

To switch between cubed and crushed, press ICE

SELECTION.

2. Press a sturdy glass against the dispenser pad.

Hold the glass close to the dispenser opening so ice does not fall outside of the

glass.

IMPORTANT: You do not need to apply a lot of pressure to the pad in order to

activate the ice dispenser.

Pressing hard will not make the ice dispense faster or in greater quantities.

NOTE:

 Ice may continue to dispense for up to 10 seconds after removing the glass from

the pad.

 The dispenser may continue to make noise for a few seconds after dispensing.

 IMPORTANT: Limit ice dispensing time to a maximum of 2 minutes at a time.

3. Remove the glass to stop dispensing.