Installation guide

WHIRLPOOL CORPORATION  TRAINING
Water and Ice Dispensers
 84
On some models!
1
•After
connecting
the
refrigerator
to a water
source or
replacing the
water filter
•Flush the
water
system.
2
•Use a sturdy
container to
depress and
hold the
water
dispenser
pad for 5
seconds
•Then release
it for 5
seconds.
•Repeat until
water begins
to flow.
3
•Once water
begins to
flow,
continue
depressing
and releasing
the dispenser
pad
•(5 seconds
on, 5 seconds
off)
•Until a total
of 12 litres
has been
dispensed.
4
•This will flush
air from the
filter and
water
dispensing
system, and
prepare the
water filter
for use.
5
•Additional
flushing may
be required
in some
households.
6
•As air is
cleared from
the system,
water may
spurt out of
the
dispenser.
IMPORTANT STEPS