Installation guide

WHIRLPOOL CORPORATION  TRAINING
Basic Instructions – Re-Assembling the Door – SW-3
1. Re-assemble hinge to the cabinet. Make sure leveler bracket is in
place.
1. May require a deep drive to reach the screws
2. Requires door to be held while one person assembles hinge to cabinet
3. Hold door around 90-degrees so that the screws can be accessed
2. Replace the top hinge…
3. Reconnect water tubes and wiring
1. Do not intertwine….
2. Reconnect electrical connections….
3. Re-assemble bracket to the crossbar….
4. Strain relief…same as SN34
4. Add top hinge….