User Manual

INSTALLATION
Install flue cover wall mounting brackets with
suitable fasteners. Suitable fasteners must be used for
rangehood mounting points . Refer to Fig.5 for dimensions.
If installation is for recirculation mode refer to Item 6a and
Fig.9.
3.
Fit the dampers to the exhaust air outlet.
Slight bending of the dampers will be required
for the fitment.
4.
Recirculating mode(Fig.9)
6a.
INSTALLATION
Hang the body hood on the mounting screws then
secure at the anti-tilt locations(2 places) as indicated in Fig 8.
5.
8
Fig.6
Fig.8
Fig.7
Depending on the preferred installation/ducting mode,
follow step 6a or 6b below.
Fix the T-piece to the top mounting bracket by
using the 4 screws supplied as dimension indicated Fig 5.
Adhere two sponge to the outlet of T-piece.
Using the centre line, install the recirculating T-piece and
mounting bracket to the wall.
Install flexible pipe between T- piece and air outlet
Use cable ties or suitable duct tape to secure flexible pipe
to T-piece and outlet of the hood.(Fig.10)
Fig.9
Fig.10
NOTE: When installed in recirculating mode, it is
recommended to use a charcoal filter to prevent odours
being emitted back into the room.
For instructions on fitting charcoal filter, please refer to
page 11.
T-piece mounting bracket
Flue cover mounting bracket
T-piece mounting bracket
Flue cover mounting bracket