User Manual

USING YOUR RANGEHOOD
Best results are obtained by using a low speed for
normal conditions and high speed when odours are
concentrated.
Turn on the hood on a few minutes before you start
cooking.
The hood should be left on for a minimum of 5
minutes after cooking or until all odours have
dispersed.
The control switch are located on the front of
the unit. See below
Turning on/off the lamp
Press button to turn on the lamp, press once again
to turn off the lamp.
Turning on/off the fan
Press button , or to choose different fan speed according
to cooking conditions, press button to turn off the fan
NOTE: This product is fitted with a safety cutout device.
If the cooker hood is installed too close to the cooktop,
flambe cooking, operating the cooktop without cooking
utensils and blocked filters may activate the safety cutout
device.
CARE & MAINTENENCE
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions
to ensure the best possible result is achieved without
damage.
Clean the outside of the hood using a damp cloth and
a solution of water and mild washing up liquid. Clean
the surfaces using non-abrasive cleaning products.
Use of a soft cloth reduce the risk of scratching. If
the cloth is wet ensure that a dry soft cloth is used
to wipe down the surface.
Cleaning the hood
Never use corrosive, abrasive or flammable cleaning
products or products containing bleach.
Never insert pointed objects in the motors protective
grid.
Only ever clean the switch panel and filter grill using a
damp cloth and mild washing up liquid.
It is extremely important to clean the unit and change
the filters at the recommended intervals. Failure to do
so will cause grease deposits that could cause a fire.
Removing the metal grease filters
Push the grease filter and then pull it down and out.
USING YOUR RANGEHOOD
10
Clean regularly after use to remove any residues from
cooking, especially residues from acidic fruits,
yoghurts & milk based products.
Fig.16