Installation

INSTRUCTIONS
In order to correctly install your appliance please refer
to the user manual supplied with your rangehood for full
details or download the user manual by scanning the
below QR code.
To install your flue cover extension, please follow steps 1-8
below (as per the user manual).
Upon completion of step 8, please follow step 9a and 9b
below to replace the upper flue cover which is included
with your rangehood, with this accessory flue cover
extension.
You will need to replace the upper flue cover which is
included with your rangehood, with this accessory flue
cover extension.
NOTE: The flue cover extension MUST be used in
conjunction with the lower flue cover.
Scan the QR code below to download the full
WRC604 rangehood user manual:
Installation
1. Using a spirit level mark a vertical centre line on
the wall where the hood is to be positioned, and a
horizontal line at the hood base position.
NOTE: The height of the underside of the hood
body must be a minimum of 600mm* to a maximum
height of 800mm.
*If the instructions of the hob specify a greater
distance than the minimum above, then that shall be
the minimum height for installation.
2. Mark the location for the flue cover wall mounting
brackets and rangehood mounting points and anti-tilt
fixing points above the hood base using the hood
base as a reference point.
WARNING
WARNING
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
Top mounting
bracket for T-piece
(optional part)
Bottom mounting
bracket for flue
cover (required
where ceiling
cornice is in place)
Rangehood
mounting
points
Anti-tilt
fixing
points
Electric
Gas
Fig. 5
350
Min 600mm
Max 800mm
Min 650mm
Max 800mm
192
130
140
30
273
55
3. Install flue cover wall mounting brackets with
suitable fasteners. Suitable fasteners must be used
for rangehood mounting points. Refer to Fig.5 for
dimensions. If installation is for recirculation mode
refer to Item 6a and Fig.9.
Fig.6