User manual

INSTALLATION
PRE-INSTALLATION
Before installing the cooker hood, peel off any protective coating.
INSTALLATION
1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line
at the hood base position. (See Figure 4, 5, or 6 for relevant model)
NOTE. The height of the underside of the hood body must be a minimum of 600mm* to a maximum height of 800mm.
* If the instructions of the hob specify a greater distance than the minimum above, then that shall be the minimum
height for installation.
2. Mark the location for the flue cover wall mounting brackets and rangehood mounting points and anti-tilt fixing
points above the hood base using the hood base as a reference point
130 mm
250 mm
230 mm
286 mm
587 mm
40 mm
250 mm
250 mm
Max. 1100 mm
An lt fixing point
Range hood
mounng points
Flue cover wall
mounng brackets
ceiling
Min. 600 mm*
Max. 800 mm
Top of hob
Fig. 7
7
LOCATION
The hood is to be mounted on the wall. When installed, the hood must be not less than 60cm above electric burners or
65cm above gas or mixed-fuel burners.
Distance from hood base to top of hob
hob type minimum* maximum
gas 650mm 800mm
electric 600mm 800mm
* If the instructions of the hob specify a greater distance than the minimum above, then that shall be the minimum height
for installation.